Operating Instructions
OIE 12en Edition 2019-02
37
Menu 2: General settings
M
e
n
u
d
e
s
c
ri
p
ti
o
n
2.02 Change password
After the valid password has been entered, the
password can be changed on this page.
2.03 Select mode
Selection of the mode is adjusted to the
measuring task.
When a mass unit is selected, the system
changes automatically to the mass calculation
mode.
2.04 Select temperature X
The reference temperature is set in this dialog.
This setting is only effective if "Volume at X°" has
been selected under "2.03 Select mode".
2.05 Select unit rate
The unit of the rate can be selected in
accordance with the requirements from a list.
2.06 Select unit total
The unit of the total can be selected in
accordance with the requirements.
2.07 Select unit temperature
The unit of the temperature can be selected in
accordance with the requirements.
2.08 Select unit density
The unit of the density can be selected in
accordance with the requirements.
Setting
Meaning
Volume
Volumetric flow rate
measurement without
consideration of temperature
influences.
Volume at
X°
Q, QA or QB are converted with
temperature and density table to
mass. Then the density table is
used to convert to Volume at X°
that is also displayed in this form.
The reference temperature X°
can be selected freely, see "2.04
Select temperature X", page 37.
Volume at
TempA
Calculates the consumption at
the temperature Volumeter A.
This temperature usually
corresponds to the temperature
of the fluid in the reservoir.
2.02 Setting
Change
Password:
No
2.03 Setting
Select
Mode:
Volume
2.04 Setting
Select
Temperature X:
15.0 °C
2.05 Setting
Select Unit
Rate:
l/min
2.06 Setting
Select unit
Total:
l
2.07 Setting
Select unit
Temperature:
°C
2.08 Setting
Select unit
Density:
kg/m3
