Kraissmann 2500HDRi170, Instructions Manual, Page: 11 / 24

10 | English Pressure Washer | 11
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60335-1.
L
pA
sound pressure level ........................................ 77 dB(A)
K
pA
uncertainty ....................................................................3 dB
L
WA
sound power level ............................................ 94 dB(A)
K
WA
uncertainty ...................................................................3 dB
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three direc-
tions) determined in accordance with EN 60745.
• Vibration emission value ah ≤ 2.5 m/s2
• K uncertainty = 1.5 m/s2
Warning!
The specified vibration value was established in ac -
cordance with a standardized testing method. It may
change according to how the electric equipment is
used and may exceed the specified value in excepti -
onal circumstances.
The specified vibration value can be used to compa -
re the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations
to a
minimum.
▶ Only use appliances which are in perfect working
order.
▶ Service and clean the appliance regularly.
▶ Adapt your working style to suit the appliance.
▶ Do not overload the appliance.
▶ Have the appliance serviced whenever necessary.
▶ Switch the appliance off when it is not in use.
▶ Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment’s
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or is
not properly guided and maintained.
STARTING
For Your Safety
Warning! Switch off, remove plug from
mains before adjusting, cleaning or if ca-
ble is cut, damaged or entangled.
Your pressure washer requires an earth connection.
The operating voltage is 230 V AC, 50 Hz (for non-EU
countries 220 V, 240 V as applicable). Only use appro-
ved extension cables. Contact your Kraissmann Ser-
vice Centre for details. If you want to use an extension
cable when operating your high pressure washer, only
the following cable dimensions should be used:
- 2.5 mm2 – max length 20 m
- 4.0 mm2 – max length 50 m
Note: If an extension cable is used it must be eart-
hed and connected through the plug to the earth cable
of your supply network in accordance with prescribed
safety regulations.
If in doubt contact a qualified electrician or the nea -
rest Kraissmann Service Centre.
Warning! Inadequate extension cables
can be dangerous. Extension cable, plug
and socket must be of watertight const-
ruction and intended for outdoor use.
Cable connections should be kept dry and off the
ground. For increased electrical safety to use a Re-
sidual Current Device (RCD) with a tripping current of
not more than 30 mA. Always check your RCD every
time you use it. If the supply cord is damaged, it must
be replaced by a Kraissmann Service Centre.
Products sold in GB only: Your product is fitted
with an BS 1363/A approved electric plug with internal
fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it
should be cut off and an appropriate plug fitted in its
place by an authorized customer service agent. The
replacement plug should have the same fuse rating as
the original plug. The severed plug must be disposed
of to avoid a possible shock hazard and should never
be inserted into a mains socket elsewhere.
For products not sold in GB
Warning!
For your safety, it is required that the plug
attached to the machine is connected with the exten-
sion cord. The coupling of the extension cord must be
protected against splash water, be made of rubber or
coated with rubber. The extension cord must be used
with a cable strain relief.
Drawing in water from open reservoirs.
• Screw the suction hose with filter (special suction