9
2. Open gas supply tank valve.
3. Make sure control knob of heater is
in the OFF position.
4. Check all joints from equipment
shutoff valve to co ntrol valve
(LP GAS see Figure 9.1 NATURAL
GAS see Figure 9.2). Apply
mixture of liquid soap and water
to gas joints. Bubbles forming
show a leak.
5. Correct all leaks at once.
6. Light heater (see Operating
Heater). Check all other internal
joints for leaks.
7. Turn off heater (see To Turn Off
Gas Appliance).
WARNING:
Failure to position
the parts in accordance with these
diagrams or failure to use only parts
specifically approved with this heater
may result in property damage or
personal injury.
CAUTION:
After installation and
periodically thereafter, check to en-
sure th at n o flame c omes in
contact with any log. With the heater
set to High, check to see if flames
contact any log. If so, reposition logs
according to the log installation
instructions in this manual. Flames
It is very important to install the logs
exactly as instructed. Do not modify
logs. Only use logs supplied with
heater.
IMPORTANT
: Make sure log does
not cover any burner ports (see Fig-
ure 10).
Also, see log placing instructions.
Figure 10 -Installing Log Set (Top View)
Figure 9.2 -Checking Gas Joints
Test Pressures Equal To or
Less Than 1/2 PSIG(3.5 kPa
)
1. Close equipment shutoff valve
(see Figure 8).
2. Pressurize supply piping system
by either using compressed air or
opening natural supply tank
valve.
3. Check all joints from gas meter to
equ ipment shutoff valve(see
Figure 9). Apply mixture of liquid
soap and water to gas joints.
Bubbles forming show a leak.
4. Correct all leaks at once.
INSTALLATION INSTRUCTIONS FOR LOG
PLACEMENT
1. LOGS
FIG(1)
FIG(2)
STEP 1: Install log 1 on the
left rear bracket .
STEP 2: Install log 2 on the
right rear bracket .
STEP 3: Install log 3 into slots on
the front bracket .
STEP 4: Place recessed hole on the
bottom part of log 5 onto the pin on log
2. Place the lower part of log 5 on the flat
area at the right side of log 3 .
STEP 5: Place recessed hole on the
bottom part of log 4 onto the pin on log
1. Place the lower part of log 4 on
the flat area at the left side of log 3 .
FIG(3)
FIG(4)
FIG(5)
FIG(6)
