10
INSTALLATION
Continued
WARNING:
Failure to position
the parts in accordance with these
diagrams or failure to use only parts
may result in property damage or
personal injury.
CAUTION:
After installation and
periodically thereafter, check to en-
sure that no flame comes in
contact with any log. With the heater
set to High, check to see if flames
contact any log. If so, reposition logs
according to the log installation
instructions in this manual. Flames
contacting logs will create soot.
INSTALLING LOGS
It is very important. To install the logs exactly as instructed. Do not modify
logs. Only use logs supplied wall heater.
IMPORTANT: Make sure log does not cover any burner ports (see Figure 10).
Figure 10 -Installing Log Set
FIG(1)
FIG(2)
STEP 1: Install log 1 onto the two slots in
the rear plate as shown.
STEP 2: Install log 2 onto the two slots in
the left middle plate. Install log 3 onto the
two slots in the right middle plate.
STEP 3: Install log 4 onto the two slots in
the front plate.
FIG(3)
FIG(4)
STEP 4: Insert the recessed hole on the
bottom of log 5 onto the pin on log 2, with the
front of log 5 placed on flat surface of log 4.
Insert pin on bottom of log 6 into hole in log
3, with the front of log 6 placed on flat surface
of log 3
FIG(5)
1. All logs. See FIG(1).
10