NOTE: A complete electric fireplace heater should consist of two parts, the wooden mantle
and the fireplace heater each packed in a separate carton. It is not recommended to use the
fireplace heater without the wooden mantle. Unpack the fireplace heater and mantle.
Remove all packing materials.
PARTS LIST:
A) Top panel
1
B) Base panel
1
C) Side panel
2
D) Front panel
2
E) Upper front panel
1
F) Lower front panel
1
S) Connector
2
T) Short KD screws
3
U) Mounting clips
3
V) Mounting brackets
2
W) KD screws
51
X) Plastic connector
13
WARNING:
Make sure the fireplace INSERT controls are in the OFF position and the
INSERT is NOT plugged in.
CAUTION:
Place a piece of cardboard or protective sheet on the floor in order to avoid
scratching the decorative surface of your mantle during assembly.
Please
DO NOT
fully tighten the KD screws until all panels are assembled.
Step 1: Attach 2 CONNECTORS (S) to the UPPER FRONT PANEL (E) with 4 KD SCREWS
(2 screws for each side). See Figure A.
Step 2: Attach all PLASTIC CONNECTORS (X) to the PANELS (C, D, & E) as shown in
Figure B (2 screws for each PLASTIC CONNECTOR).
4
ASSEMBLY INSTRUCTIONS