Kozy-World EF5524KD Installation Instructions And Homeowner'S Manual Download Page 4

WARNING

:  This is a 1500 watt heater and parts become hot when in use.  Be sure to main-

tain a personal distance and keep any combustible material at least three (3) feet away from
the front of the heater.  The area directly behind, around and under the heater must be clear
and free of any obstructions.  

LOCATING YOUR ELECTRIC FIREPLACE

Your new freestanding electric fireplace may be installed virtually anywhere in your home.
However, when choosing a location for your new electric fireplace, ensure that the general
instructions are followed.  For best results, install the electric fireplace out of direct 
sunlight.

CLEARANCE TO COMBUSTIBLES

ELECTRICAL SPECIFICATIONS

ELECTRICAL CONNECTION

A 15 AMP, 120 Volt, 60Hz circuit with a properly grounded outlet is required.  Preferably, the heater will
be on a dedicated circuit.  Other appliances on the same circuit may cause the circuit breaker to trip or
the fuse to blow when the heater is in operation.  The unit comes standard with a 6' (1828mm) long
three wire cord exiting from the rear of the fireplace.  Plan the installation to avoid the use of an 
extension cord.  If an extension cord must be used, it must be a minimum 16 AWG three wire with
grounding type plug connector and rated no less than 1900 Watts.

3

WARNING:  Procedures and
techniques, which, if not 
carefully followed, will expose
the user to the risk of serious
injury, illness or death.

WARNING:  Procedures and
techniques, which, if not 
carefully followed, will result
in damage to the equipment
or personal property or may
cause personal injury.

KEEP CHILDREN AND PETS AWAY FROM HEATER AND CONTROLS

Back………….…4"/0mm
Sides……………0"/0mm
Floor…….………0"/0mm
Top…….........….24"/610mm
Front..................36”/915mm

Voltage................120 VAC/60Hz
Total Amps...........11.3 Amps
Total Watts...........1500 Watts
Heater Ratings.....1400 Watts (+5%, -10%)

WARNING:  Electrical 
outlet wiring must comply with
local building codes and all
other applicable 
regulations to reduce the risk
of fire, electrical shock and
injury.

WARNING:  Do not use this
fireplace if any part of it has
been under water.  Immediately
call a qualified service 
technician to inspect the 
fireplace and replace any part
of the electrical system if 
necessary.

Summary of Contents for EF5524KD












Reviews: