31
1. Remove safety barrier.
2. Remove glass valance assembly. Refer to 13.1 Glass Frame Assembly, on page 29.
3. Remove (10) screws securing burner cover, then lift the cover out of the firebox. See Figure 13.3.
4. Install (6) halogen bulbs (included in components packet) into lamp bases.
5. Reinstall burner cover, securing with screws previously removed.
ATTENTION
If converting to LP (propane) gas, do so now before installing light kit components. Follow instructions provided with the conversion kit (sold
separately).
CAUTION
Disconnect all electric power from the fireplace before performing this task.
NOTE
To avoid damage and prolong the life of halogen bulbs, never touch with bare hands. Always use a soft cloth when handling.
13.3
Light Kit
13.3.1
Install Light Kit
Figure 13.3, Screw Location on Burner Cover
Figure 13.4, Halogen Bulb Installed
IMPORTANT
Use ONLY #101 Series Glass Media (10 lbs. / 4.5 kg) in this fireplace. DO NOT substitute materials, or use more than specified.
Glass media must be one layer deep across the entire burner area to avoid possible delayed ignition / sooting issues.
13.4
Glass Media
13.4.1
Install Glass Media
Install glass media onto burner assembly and pilot shield, being careful not to block pilot assembly.
WARNING
DO NOT BLOCK PILOT ASSEMBLY WITH GLASS MEDIA; A BLOCKED PILOT MAY CAUSE DELAYED IGNITION!
DO NOT BLOCK
THIS AREA
Figure 13.5, Pilot Assembly Location
