#NDK-34-i R.1 July 2022
3
8
Hussong Mfg. Co., Inc. Kozy Heat Fireplaces
11.7.11
AUX1 Function (Top Light Kit)
11.7.13 Timer Adjustment
The light kit intensity can be adjusted through (4) levels: HIGH,
MEDIUM, LOW, and OFF.
The system will remember the previous AUX1 setting from the menu.
However, when the appliance is turned OFF, AUX1 function will be
turned off. AUX1 can be activated when the remote control is OFF.
When the appliance is turned back ON, the AUX1 setting will be
restored to the previous ON setting.
To activate this function,
1.
Press the MENU button to activate the menu.
2.
Using the UP and DOWN arrows, highlight the AUX1 icon and
press SELECT.
3.
Use the UP and DOWN arrows to adjust to desired light kit
intensity.
•
The transmission indicator icon will flash and a single beep will
confirm the reception of the command.
This control system has the option to set a timer function to turn OFF
the main burner operation. The timer operates in increments of 15,
30, 45, 60, 90, 120, and 180 minutes.
To activate this function,
1.
Press the MENU button to activate the menu.
2.
Using the UP and DOWN arrows, highlight the TIMER icon and
press SELECT.
3.
Use the UP and DOWN arrows to turn the TIMER ON or OFF, then
press select.
4.
Using the UP and DOWN arrows, select the desired set time and
press SELECT.
•
The transmission indicator icon will flash to confirm the
reception of the command.
11.7.12 AUX2 Function (Ember Bed Light Kit)
The ember bed light kit can be turned on and off using the AUX2
function. The system will remember the previous AUX2 setting from
the menu. However, when the appliance is turned OFF, AUX1
function will be turned off. AUX2 can be activated when the remote
control is OFF. When the appliance is turned back ON, the AUX1
setting will be restored to the previous ON setting.
To activate this function,
1.
Press the MENU button to activate the menu.
2.
Using the UP and DOWN arrows, highlight the AUX2 icon
and press SELECT.
3.
Use the UP arrow to turn “ON” and the DOWN arrow to
turn “OFF”.
•
The transmission indicator icon will flash and a single beep will
confirm the reception of the command
Adjust Ember Bed Light Kit Intensity (after turning “ON”)
The ember bed light kit intensity can be adjusted by using the
ember bed light kit modulator knob located on the left side of
the firebox (FIGURE 11.2). To adjust,
1.
Remove the safety barrier screen by lifting the screen up
and out of the slots.
2.
Turn the knob counterclockwise to decrease the light
intensity.
3.
Turn the knob clockwise to increase the light intensity.
4.
Reinstall safety barrier screen when finished.
FIGURE 11.2
Bottom light kit dimmer switch
OPERATING I
NSTRUCTIONS
