SECTION 6
VENTING
22
#LXL-22-L
R.1 4 . 2 0 . 2022
HUSSONG MFG. CO., INC.
KOZY HEAT FIREPLACES
6.3
Vent Restriction
6.3.2 Baffle Restrictor
Approved Vent Systems–Vent Restriction
Burner flame appearance and characteristics are affected by altitude,
fuel quality, venting configuration, and other factors. To achieve
desirable flame appearance, the vent exhaust may be restricted
by the restrictor plate (included in components packet) and/or by
adjusting the built-in restrictor wheel located in the baffle in the gas
stove firebox.
For vent restriction recommendations and adjustments, see
section
10.2.2, VENT RESTRICTION (AFTER INSTALLATION)
on page 40.
6.3.1 Restrictor Plate
The restrictor plate is shipped with all inner rings intact, and when
installed, provides the most vent restriction. There are (2) inner rings
that can be knocked out. The innermost ring knocked out will create
less restriction, and the outer most ring knocked out will create the
least amount of restriction.
Follow
FIGURE 7.1
for restrictor plate installation before attaching
venting, or through the baffle if venting is already attached.
This gas stove is shipped with the baffle restrictor set in position 1
(wide open). Position 1 is the least restriction, and position 5 is the
most restriction. To adjust the baffle restrictor,
1.
Remove the safety barrier and glass frame assembly.
2.
Remove and save (1) screw to adjust the baffle restrictor to
achieve desired flame appearance.
3.
Secure the baffle restrictor when finished with (1) screw
previously removed.
4.
Reinstall all components previously removed.
Restrictor plate
Bend tabs to approx. 80° angles to create
tension to hold itself in place when installed
Remove innermost circle
to create less restriction
Remove all inner rings for
the least restriction
Slide restrictor plate into exhaust pipe on
top of the gas stove with the tabs facing
towards you prior to attaching venting
Insert restrictor plate into exhaust pipe with tabs
pointing towards you if installing after venting is attached
FIGURE 6.1
Restrictor Plate Installation
FIGURE 6.2
Baffle Restrictor Adjustments
