#CLW-ST R.1 February 2021
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FIREPLACE SETUP
57
8.0 FIREPLACE SETUP
8.1 Glass Frame Assembly
WARNING: Do not operate this fireplace with the glass removed,
cracked, or broken. Replacement of the glass assembly should be done
by a licensed or qualified service person.
WARNING: Do not remove the glass assembly when hot.
This fireplace has a front and back side. The front is marked “ACCESS
SIDE” with a glass frame assembly with spring loaded latches. The back
glass frame assembly is fixed by flange nuts.
8.1.1 Front/Access Side Glass Frame Assembly
8.1.1.1 Remove Front Glass Frame Assembly
1. Remove the safety barrier screen.
2. Locate (4) spring-loaded latches securing the front glass
assembly at the top of the firebox. Use the provided tool to
unlatch the latch assemblies from the flange on top of the front
glass valance. See Figure 8.1.
3. Tilt the top of the front glass valance forward and lift up to
remove the front valance resting on the bottom frame rail.
8.1.1.2 Install Front Glass Frame Assembly
1. Tilt the top of the front glass valance forward and align the glass
valance with the bottom frame rail
2. Use the provided tool to pull the (4) latch assemblies to latch
with the flange on top of the front glass valance. See Figure 8.1.
3. Reinstall safety barrier screen.
Bottom frame rail
Glass valance on frame rail
Valance against unit
Provided latch tool attached
to top latch assembly
All four latches securing valance
Figure 8.1, Front/Access Side Glass Frame Assembly Removal
8.1.2 Back/Fixed Side Glass Frame Assembly
8.1.2.1 Remove Back/Fixed Glass Frame Assembly
1. Remove the safety barrier screen.
2. Locate the (3) 7/16” flange nuts below the fireplace opening
securing the back/fixed glass frame assembly. See Figure 8.2.
Remove and save flange nuts.
3. Lift the back/fixed glass assembly up and off of the (3) tabs
located at the top of the firebox. See Figure 8.2.
8.1.2.2 Install Back/Fixed Glass Frame Assembly
1. Align the slots on top of the back/fixed glass assembly over the
tabs at the top of the firebox while lowering the bottom of the
back/fixed glass assembly into position.
2. Secure back/fixed glass assembly. Align the holes in the valance
with the studs below the fireplace opening. Secure with (3) 7/16”
flange nuts previously removed.
3. Reinstall safety barrier screen.
Figure 8.2, Back/Fixed Side Glass Frame Assembly
Remove (3) 7/16” flange nuts
Lift glass assembly up and off tabs
