PL;DE;FR;GB-062A_f.1125
29
Follow the guidelines below for safety and trouble-free cylinder operation:
•
Check out the safety valve performance once every 14 days. Do not use the cylinder
if the water does not come out (it indicates that the valve is broken).
•
Clean inside of the cylinder periodically. The frequency of cleaning depends on the
degree of water hardness. The cleaning should be done by a qualified person.
•
The wear condition of the anode must be inspected annually.
•
The anode must be replaced once every 18 months.
- anode rod replacement [3]: take off anode’s blank [10], take out an insulation ring,
turn off the cut-off valve on cold water supply pipe, turn on the hot water valve (mixer
tap), turn the drain valve on, drain as much water as you need to easily unscrew
the anode rod (avoiding room flooding). Remove the cork and unscrew the anode
rod.
•
Heat up the water above 70°C periodically for hygiene reasons.
•
Failures or malfunctions notify to the seller.
•
Insulate the outlet pipe and heating coil connection pipes to minimise the heat loss
(recommended).
Above activities are beyond of the scope of warranty service (should be done by the user).
Operation
Before the start-up make sure that the installation procedures have been carried out in
accordance with the regulations included in this manual. Cylinder must be filled with water:
With the filling of cylinder, you should follow the order:
- first of all,fill the tank of domestic water,
- then, fill the tank jacket.
•
turn on the valve on cold water supply pipe,
•
turn on the hot water outlet valve (water outflow without the air bubbles indicates
that the tank is full),
•
turn off the outlet valves,
•
turn on the heating medium valves ,
•
vent heating circuit- if need be.
Check for water and heating medium leaks. Check out the safety valve performance in
accordance with valve manufacturer’s instruction.
Start-up
GB
