Kospel EPS - 3,5, Manual

Page: 3 / 8

ENG-001B/p.410 3
Fig.1 View
[1] – work indicator
[2] – power changing knob (EPS-5,5R)
[4] – gaskets
[5] – filter
[6] – water supply
[7] – rosette
[8] – tap body
[9] – spray-head
[10] – nuts
[11] – tap pipe
Installation
1 2
Fig.2 Electric connection
F – dipolar circuit breaker
L – live wire
N – neutral wire
PE – earth wire
BN - brown
BU - blue
GNYE - green-yellow
Installation
1. Fix the tap set [6] on a water supply pipe [8].
2. Connect the heater to the tap body [8] with nuts [10] accompanied by gasket [4] and the filter [5].
3. Allow water mains pressure gets to the tap.
4. Check for leaks by opening the tap. Do it without the spray-head [9] on, as some impurities, which
come from the installation, may appear.
5. Vent the water installation.
6. Put the spray-head on.
7. Connect the heater to a power source (through the installation cable box according to Fig.2).
Recommendation
- connect the appliance to cold water supplies only.
ATTENTION!
Electric installation should be equipped with safety (power-differential) circuit breaker and
other devices which will ensure disconnecting the heater from the source of power (intervals
between all their poles should not be less than 3mm).