12
Stand-by mode
In stand-by mode the pump is activated everyday for 2 min, which prevents seizure of
the pump. To switch between stand-by mode and summer/winter mode press and hold
the power button for 3 seconds.
Stand-by is indicated by briefly showing on the display followed by the display turning
blank.
Pressing or
buttons displays parameter of installation pressure. After 1 min of
inactivity the display becomes blank again. Pressing
, button in the stand-by mode
shifts boiler’s operation to winter or summer mode depending on the valid settings
adjusted before activation of stand-by mode.
Winter mode (CH)
Winter mode is activated when
icon is on.
In winter mode control panel displays pictograms which describe current boiler's
operation mode- digital display indicates heating medium's temperature.
Pressing
button shifts to the preview of current parameters and settings of boiler's
operation in the following order:
-
domestic water temperature setting (indicators L and D). Using buttons
or
- you can change the domestic water setting value,
-
domestic water temperature at the inlet (indicators I, L, D),
-
domestic water temperature at the output (indicators J, D and L),
-
value of water flowing through the heater (indicators L and B),
-
current power consumed by the water heater (indicators C and L),
-
CH medium temperature adjustment (indicators K and D), indicator H is on when
weather compensation regulator is active (advanced settings). Indicator H flashes
when there is no possibility to determine installation temperature due to the lack or
failure of outside sensor- the boiler shifts to manual adjustments. Pressing
or
buttons when heating medium temperature is indicated on the display results
in heating medium value change. Note, it works only when weather compensation
regulator is switched off (advanced settings - parameter C=0) or when there is no
outside sensor,
-
inlet temperature CH (indicators I, K and D),
-
outlet temperature CH (indicators J, K and D),
-
outside temperature (indicators F, D, K),if the weather compensation regulator is
disabled, the parameter is ignored. In case of a failure of the external sensor and
the weather compensation controller is turned on, are shown on the digital display
characters such as “---”
-
flow of the medium through the boiler (indicators K and B),
-
pressure in CH installation (indicators K and A),
-
current power charged by boiler (indicators K and C).
If the control panel is in the preview / parameter setting mode, pressing the
button
or if the keyboard is not used for 1 minute, it will return you to the main view.
