Kortho
Hot Quickcoder User manual
18
8
DEACTIVATING THE HOT QUICKCODER
8.1
Stopping printing for a short time
If the HQC is deactivated
for a short time
(during a break), the STOP button on the Control Panel
should be pressed. The thermostat part of the Control box continues to operate normally. When
production is resumed, the START button on the Control Panel must be pressed and the QC is ready
for immediate use.
8.2
Stopping printing for a longer time
If the HQC is deactivated
for a longer time
(several days):
1.
Stop the supply of products;
2.
Activate the HEAD-OUT button on the Control Panel;
3.
Remove the Hotroll from the coding part of the HQC;
4.
Activate the HEAD-IN button on the Control Panel. This moves the text head back into
neutral position;
5.
Now switch off the HQC using the OFF button on the Control Panel;
6.
If necessary, remove the air pressure from the system;
7.
If desired, resume the supply of products;
When the system is
started up again
, you should take account of the requisite heating up time of 15
to 20 minutes (see section 5.1).
!
WARNING:
Failure to observe the requisite heating up time of ~15 minutes leads to irrevocable damage to the
text material and the Hotroll!