50
Effects
The SGproX offers two effect units connected in series: effect 1 (FX1) and effect 2
(FX2).
Effect 1 lets you select one of 12 types of effect, and effect 2 lets you select one of 11 types.
Effect settings can be made independently for each program, and effect routing can be set for each perfor-
mance.
When using a layer or split in Program mode, or when playing two programs at the same time (timbres A and B),
the settings of the first program (timbre A) will control the effect. You will need to select whether the second
program (timbre B) will be input at a point before or after effect 1.
Depending on the sound and the effects which you are using, the output may be distorted. If this occurs, adjust the
Program Edit mode “2. Level” setting, and/or the effect parameters “Effect Depth” and “Trim” etc.
●
EFFECT ON/OFF switch
Effects 1 and 2 can be simultaneously switched on/off from the front panel.
When the effect type is set to “NO EFFECT,” the switch can still be turned on/off, but there will be no effect
when this switch is turned on.
In the case of the 3. Stereo Delay, 4. Stereo Chorus and 9. Auto Pan effects, the equalizer (EQ Low, EQ Hi) settings
will remain valid even when the effect is turned off.
●
Dynamic modulation
For the Rotary Speaker and Wah effects, you can apply modulation to the effect itself. Specific effect param-
eters such as modulation speed or cutoff frequency can be controlled while you play, giving you more
expressive control.
The modulation source that will be used for control can be selected from the assignable controllers (AW1,2,
AL1to 4, AP, AS), Damper, Amp-EG, and MIDI (CC#12).
In order to select an assignable controller as the modulation source, you will need to set the function of the
selected controller to [ Fx Dyna Mod ]. Refer to
Controller / MIDI ( p.55).
FX1
TYPE
DEPTH
PARAM
FIRST
PROGRAM
OUT PUT
FX2
TYPE
DEPTH
PARAM
SECOND
PROGRAM
PERFORMANCE MODE
PROGRAM MODE (Layer, Split)
FX1 USE
FX1 PASS
FX1
TYPE
DEPTH
PARAM
Timbre A
OUT PUT
FX2
TYPE
DEPTH
PARAM
FX1 USE
FX1 PASS
PAN
PAN
Timbre B
Effect routing display for Program mode (Layer, Split)
In this display, the second program passes through both effects 1 and 2
In this display, the second program passes through only effect 2
Effect routing display for Performance mode
In this display, timbre B passes through both effects 1 and 2
In this display, timbre B passes through only effect 2
