19
Wave Shape:0
Wave Shape:99
Table valiation
Type (Wave Shap Type)
[1, 2]
1: The signal after wave shaping will be output
without further change. If “Shape” is set to the
minimum value, the phase modulated signal will be
output essentially without change.
2: A rounded waveform will be obtained regardless of
the “Shape” value.
AMS1 (Alternate Modulation Source 1)
[Off…MIDI:CC#83]
Selects a modulation source 1 (
☞
p.48 of this manual)
that will control “Wave Shape” value.
Intensity (Shape AMS1 Intensity)
[–99…+99]
Specifies the depth and direction of the effect of “AMS1.”
AMS2 (Alternate Modulation Source 2)
[Off…MIDI:CC#83]
Selects a modulation source 2 (
☞
p.48 of this manual)
that will control “Wave Shape” value.
Intensity (Shape AMS2 Intensity)
[–99…+99]
Specifies the depth and direction of the effect of “AMS2.”
Feedback
[0…99]
Specifies the amount of the output after wave shaping
that will be fed back to the carrier.
1–3b: Modulator
Wave
[Saw, Square, Triangle, Sine, OSC2(1), Sub OSC,
Filter1, Filter2]
Select the waveform of the modulator.
This selects the other oscillator or sub oscillator etc.
If you set this to OSC2(1)
, SubOSC
, Filter 1
, or
Filter 2
, the Frequency Coarse
and following
settings will not be available.
Level
[0…99]
Specifies the output level of the modulator.
This value will determine the amount of modulation
that is applied to the “1–3a: Carrier” setting.
AMS1 (Alternate Modulation Source 1)
[Off…MIDI:CC#83]
Selects a modulation source 1 (
☞
p.48 of this manual)
that will control “Level.”
Intensity (Level AMS1 Intensity)
[–99…+99]
Specifies the depth and direction of the effect of
“AMS1.”
AMS2 (Alternate Modulation Source 2)
[Off…MIDI:CC#83]
Selects a modulation source 2 (
☞
p.48 of this manual)
that will control “Level.”
Intensity (Level AMS2 Intensity)
[–99…+99]
Specifies the depth and direction of the effect of
“AMS2.”
Frequency Coarse
[0.5, 1…16]
Specifies a multiplication factor which will be applied
to the pitch of the modulator, relative to the “1–3a:
Carrier” setting.
Fine
[–50…+50]
Makes fine adjustments to the pitch of the modulator.
AMS1 (Alternate Modulation Source 1)
[Off…MIDI:CC#83]
Selects a modulation source 1 (
☞
p.48 of this manual)
that will control the pitch of the modulator.
Intensity (Frequncy AMS1 Intensity)
[–99…+99]
Specifies the depth and direction of the effect of
“AMS1.”
AMS2 (Alternate Modulation Source 2)
[Off…MIDI:CC#83]
Selects a modulation source 2 (
☞
p.48 of this manual)
that will control the pitch of the modulator.
Intensity (Frequncy AMS2 Intensity)
[–99…+99]
Specifies the depth and direction of the effect of
“AMS2.”
