Korg EXB-MOSS, Manual, Page: 40 / 53

41
You can also input a value by playing a note
on the keyboard while you hold down the
[ENTER] key.
Ramp Low [–99…+99]
Specifies the way in which keyboard tracking will
affect the volume of notes below the “Key Low.”
Ramp High [–99…+99]
Specifies the way in which keyboard tracking will
affect the volume of notes below the “Key High.”
C-1 C4 C9
-50
0
Ramp> 0
0
+50
+99
Ramp<0
-99
Volume level
If Ramp Low or Ramp High are set to
positive (+) settings, you will need to lower
the “4–1a: Amp Level” Amplitude value.
4–2: Amp2 Level (Amplifier 2 Level)
Here you can adjust the settings for Amp 2. These
parameters have the same structure as the “4–1a: Amp
1” parameters.
4–3: Amp EG
(Amplifier Envelope Generator)
4–3a
4–3b
4–3c
4–3d
Here, you can make settings for the Amp EG. The
Amp EG lets you specify how the sound will change
over time. Since the Amp EG can also be used as a
general-purpose controller, it can create time-variant
change in parameters other than volume.
Note-off
Attack level Sustain level
Note-on
Attack
time Decay
time
Slope
time
Release
time
Time
Break
level
Volume
Time-variant change in volume created by the amp EG
4–3a: Level (Amp EG Level)
Attack (Attack Level) [0…99]
Specifies the volume that will be reached after the
Attack Time has elapsed.
Break (Break Level) [0…99]
Specifies the volume level that will be reached after
the Decay Time has elapsed.
Sustain (Sustain Level) [0…99]
Specifies the volume level that will be reached after
the Slope Time has elapsed.
4–3b: Time (Amp EG Time)
Attack (Attack Time) [0…99]
Specifies the time from note-on (when a note is
played) until the volume reaches the attack level.
With a value of 0, the volume will change instantly.
With a value of 99, the volume will change slowly.
Decay (Decay Time) [0…99]
Specifies the time from when the attack time ends
until the break level is reached.
Slope (Slope Time) [0…99]
Specifies the time from when the decay time ends
until the sustain level is reached.
Release (Release Time) [0…99]
Specifies the time from note-off (when a note is
released) until the volume falls to zero.
4–3c: Level Modulation
AMS (Alternate Modulation Source)
[Off…MIDI:CC#83]
Selects a modulation source (
☞
p.48 of this manual)
that will control the level of the Amp EG.
Intensity (EG Level AMS Intensity) [–99…+99]
Specifies the depth and direction of the effect that
“AMS” will have on the level of the Amp EG.