9
Phantom power is supplied to the balanced XLR jacks.
Note: If you connect or disconnect a condenser mic with the phan-
tom power switch turned on, you risk damaging your equip-
ment. Make sure that the phantom power switch is off before
you connect or disconnect a condenser mic.
Caution: Never connect any device other than a condenser mic if the
phantom power switch is on. Doing so may damage your
equipment.
7. GUITAR jack
Connect a guitar or bass guitar to this jack.
This is a 1/4" phone-type unbalanced input jack.
8. EXT1 SEND, EXT2 SEND jacks
These jacks output the signal sent from each channel to the external
sends. Connect these jacks to the inputs of your external effect proces-
sors.
9. EXT1 RETURN, EXT2 RETURN jacks
The sound received at the RETURN jacks is mixed into the master bus.
Connect the outputs of your external effect processors to these inputs.
10. BOOTH OUT jacks
These outputs provide the same audio signal as the MASTER OUT
jacks. You can use the BOOTH knob to adjust the BOOTH OUT jacks
to a different level than MASTER OUT.
These are 1/4" TRS phone-type balance output jacks.
11. MASTER OUT (XLR) jacks
These jacks output the audio of the master bus.
12. MASTER OUT (TRS phone) jacks
These jacks output the audio of the master bus.
These are 1/4" TRS phone-type balance output jacks.
13. MASTER OUT output level select switch
This switches the level of the TRS phone MASTER OUT jacks. Set this
to the appropriate position for the equipment you’ve connected.
14. FireWire connector
You can connect the ZERO8 to your computer and use it as an audio/
MIDI interface.
The two connectors operate in the same way. The connector not con-
nected to your computer can be used for daisy-chain connections.
15. DIGITAL OUT (coaxial) jack
This is a S/PDIF type digital output. It outputs the same audio as the
MASTER OUT jacks in digital form.
You can connect this to the input jack of a consumer digital audio de-
vice.
It is an RCA phono-type coaxial jack.
16. MIDI IN connector
This connector receives MIDI messages. Incoming MIDI messages can
be sent to your computer via the FireWire connector.
17. MIDI OUT connector
This connector re-transmits (“thru-es”) the MIDI messages received
from your computer via the FireWire connector. It also transmits MIDI
messages produced by the ZERO8 itself.
18. Power inlet
Connect the included power cable to this connector.
19. Power switch
Turns the power on/off.
