Korenix JetNet 6524G, Quick Installation Manual, Page: 3 / 28

The AC power connector is a standard three-pronged connector that supports the power
cord. Plug the female connector of the provided power cord into this socket, and the male
side of the cord into a power outlet. The Switch automatically adjusts its power setting to
any supply voltage in the range from 100 ~ 240 VAC at 50 ~ 60 Hz.
The stacking connector is a standard CX4 type with 10G full duplex transmission
capability. There are Status, TX, RX and Link LED to indicate the status.
DC Power Input apply to the JetNet 6524G-DC
Follow below steps to wire JetNet 6524G-DC redundant DC power inputs. The power
range support 24V(18-36VDC) or 48V(36-72V) DC input. Choose the power input model
you preferred.
Note 1: It is a good practice to turn off input and load power, and to unplug power terminal
block before making wire connections. Otherwise, your screwdriver blade can inadvertently
short your terminal connections to the grounded enclosure.
Note 2: The range of the suitable DC electric wire is from 12 to 24 AWG.
2.3 Rear Panel Description: The rear panel of the Switch contains an AC power connector
or DC power connector, a RS-232 console port, the connector for the two stacking ports.
An RS-232 DCE console port is for setting up and managing the Switch via a connection
to a console terminal or PC using a terminal emulation program. The default baud rate is
115,200, N, 8, 1.
100-240V~, 50/60HZ
Console
115200,N,8,1
1
2 1
2
10G / Stack
Status
RX
TX
Link
1. Insert positive and negative wires into V+ and V- contacts
respectively of the terminal block connector
2. Tighten the wire-clamp screws to prevent DC wires from being
loosened.
3. Power 1 and Power 2 support power redundancy and polarity
reverse protection functions.
4. Positive and negative power system inputs are both accepted,
but Power 1 and Power 2 must apply the same mode.