Korenix JetNet 3005, User Manual, Page: 19 / 24

15.2 We network enable the modems via serial-to-Ethernet converters, and
use Ethernet cables to connect Computer A and converters to the JetNet
3005. Enter Command Line mode in Computer A, and use ping command
to see if the connections between Computer A and the converters are
working properly, as described in step 10 and 11.
15.3 Enter Telnet program in Computer A, type in the IP address of one of the
converters, and configure the serial port’s communication parameters.
Follow this procedure to set up the other converters.
15.4 Install the virtual com port driver, and enter converters’ IP addresses.
15.5 Click on Computer A’s Control Panel
Æ
Device Manager, and make sure
the system each converter’s IP address is mapped to the corresponding
com port.
15.6 Click on Computer A’s Dialer, and install modem driver. Configure the
modem’s corresponding com port as a virtual com port, enter a set of
telephone number, and start dialing. Verify that the modem did dial up, and
the serial port’s communication parameters are correct. Follow this
procedure to verify each converter’s parameters are correct.
15.7 Click on Computer A’s dial out manager, and change the modem’s
setting from dial up to dial in. Follow this procedure to finish each modem’s
setting.
The industrial network is now established successfully. Computer A is able to
connect several converters using over the Ethernet via JetNet 3005 Industrial 5-port
Entry Level Ethernet Rail Converter, providing a reliable network environment.
17