Korenix JetLink 1102, User Manual

Page: 19 / 52

JetLink 1102/ JetLink 1302 User Manual
19
The fieldbus gateway is now ready for installation on its final location.
2.3
INSTALLING THE FIELDBUS GATEWAY
2.3.1
DIN Rail Mounting
The DIN rail mount option is the quickest installation option. Additionally, it optimizes
the use of rail space.
The metal DIN rail kit is secured to the rear of the fieldbus gateway. The device can
be mounted onto a standard 35 mm (1.37”) x 7.5 mm (0.3”) height DIN rail. The
devices can be mounted vertically or horizontally. Refer to the following guidelines for
further information.
Note! A corrosion-free mounting rail is advisable.
When installing, make sure to allow for enough space to properly install the
cabling.
2.3.1.1
Installing the DIN-Rail Mounting Kit
1. Position the rear panel of the fieldbus gateway directly in front of the DIN rail,
making sure that the top of the DIN rail clip hooks over the top of the DIN rail, as
shown in the following illustration.
Warning! Do not install the DIN rail under or in front of the spring
mechanism on the DIN rail clip to prevent damage to the DIN rail clip or
the DIN rail.
Make sure the DIN rail is inserted behind the spring mechanism.
2. Once the DIN rail is seated correctly in the DIN rail clip, press the front of the
fieldbus gateway to rotate the fieldbus gateway down and into the release tab on
the DIN rail clip
If seated correctly, the bottom of the DIN rail should be fully inserted in the
release tab.