1.
ON/OFF
button
Press this button to make the unit run or stop.
2.
+
or
-
button
Press
+
or
-
button to set the room setting
temperature increase or decrease.
3.
MODE
button
Each time you press this button, a mode is selected in a
sequence that goes from cool, dry and fan.
4.
TIME
button
Press this button to initiate the auto-on or auto-off time
sequence .
5.
FAN
button
This button is used for setting fan speed in the sequence
that goes from
Low
Med
, to
High
, then
back to
Low
.
Circulation
operation mode
1. Press
MODE
button in a sequence until the fan display is lighted.
2. Press the
FAN
button to select the fan speed.
3. Press the
ON/OFF
button to start the unit and press it again to stop.
Timer operation
1. Press the
TIME
button .
2. Press the
+
and
-
button to adjust your timer time.
Note :
1. Sleep function and
Auto
fan speed can be selected by remote
controller not by control panel.
2. Other functions on control panel are as same as remote controller's.
Drying operation mode
1. Press the
MODE
button in a sequence until the dry display is lighted.
2. The fan will run at a fixed speed at this operation mode.
3. Close windows and doors for the best dehumidifying effect.
4. Press
ON/OFF
button to start the unit and press it again to stop.
5
6
Operation
Failure to follow the below precaution could result in electrical shock,
fire or personal injury.
1.The plug must be plugged into an outlet that is properly installed and
grounded.
2.Do not use an extension cord or plug adaptor with this unit.
Before starting the unit
1) Select a suitable location, make sure the unit is near to an electrical outlet.
2) Install the flexible exhaust hose and the adjustable window slider kit.
3) Plug the unit into a right outlet.
4) Plug one end of drain pipe into the water full auto-drain outlet and plug the
other end plug into the windows installation board .
5) Turn the unit on.
Cooling operation mode
1. Press the
MODE
button in a sequence until the cool display is lighted.
2. Press the
+
and
-
button to set your desired set temperature.
3. Press
FAN
button to select the fan speed.
4. Press
ON/OFF
button to start the unit and press it again to stop.
Note:
Time off
is effective only when the air-conditioner is running.
Time on
is effective only when the air-conditioner is stopping.
WARNING
1
2
3
4
5
a
b
c
d
e
f
g
h
i
j
k
Control Panel
Function buttons
Function display
a-Signal receiver windows
c-Running indicator
e-Dry display
g-Cool display
I-Med speed display
k-TEMP. Display
Electric heating(cold wind type unit with out
this
)
m-
display
b-Water full indicator
d-Time display
f-Circulation display
h-Low speed display
j-High speed display
m
