22
DESCRIPTION
LOCATION AND CONNECTION
- Remove all packaging material and keep out of reach of children. After
removing the packaging, check the appliance for damage or other si-
gns of a fault/defect/malfunction. In case of doubt, do not use the ap-
pliance and contact your vendor for inspection or replacement.
- Choose a suitabe location for the heater with at least 50 cm free spa-
ce around it and with a distance of at least 20 cm to the floor
1. Blower grid Front
2. PTC Element
3. Back grid
4. Main switch
5. Operating panel
6. 90° turnable plug
7. Indicator light
Operating Panel
8. Temperature higher button
9. Temperature lower button
10. Display
11. ON/STAND BY button
12. Timer button
SET-UP AND OPERATION
- Make sure that the heater is switched off (O pushed in) then plug into
a correctly functioning 220-240 V/50 Hz socket.
- Now set the main switch to I (on); the heater is now on standby and
the indicator light (7) light up.
- Switch on the heater by pressing the ON/STANDBY BUTTON.
- After switching in by means of the main switch, the thermostat is on
the maximum 30°C. Preess the ‘Temperature lower’ button to set the
desired temperature (minimum 15°C). With the ? Temperature higher?
Button you can higher the set temperature afterwards. The display
shows the set temperature.
