45
Keep turning the adjustment bolts until the running belt is properly cen-
tered.
If the running belt is slipping during use, turn off and unplug the tread-
mill. Using the Allen Wrench provided, turn both left and right rear roller
adjustment bolts 1/4 clockwise, then turn the main power switch back
on and run the treadmill at a speed of 5-6 Km/h and check visually the
correct operation of the belt. Do not use the treadmill before having first
checked its proper functioning.
LUBRICATING OF THE RUNNING BELT
Lubricating the inner part of the running belt will ensure superior perfor-
mance and delay wear. After the first 25 hours of use (or 2-3 months)
apply some lubricant, and repeat for every following 50 hours of use (or
5-8 months).
To check the running belt proper lubrication: check the appliance is tur-
ned off and then lift one side of the running belt and feel the lower surfa-
ce of the running deck.
If the surface is slick to the touch, then no further lubrication is required.
If the surface is dry and not very flowing to the touch, then apply some
lubricant (I) providev with the treadmill packaging.
After applying the lubricant, start the treadmill, run on the treadmill at a
slow speed for 3 to 5 minutes, without getting on it, in order to facilitate
an even distribution of the lubricant in the inner surface of the running belt.
ATTENTION! DO NOT over lubricate running deck. Any excess lubricant
that comes out should be wiped off!
Allen Wrench
Tool
Summary of Contents for 5902469
Page 1: ......
Page 20: ...20 TABELLA DEI PROGRAMMI PREIMPOSTATI...
Page 43: ...43 7 PRE SET PROGRAMS CHART...
