automatically.
3.
For normal operation, please confirm:
✔
There is water in the water trough and no
overflow occurs;
✔
The pump is working properly and water is
flowing evenly on the evaporator;
✔
The compressor is running normally, the
temperature of the evaporator and the ice
making water is gradually decreasing;
✔
For air cooled machine, check the fan is
running normally, and there is stable air
flow in the inlet and outlet of the ice
machine;
✔
The ice machine has no abnormal noise;
✔
The ice machine has no abnormal
vibration;
✔
It takes about 10 to 20 minutes to make
one batch ice, depending on the ambient
temperature and the temperature of the
water. The higher the temperature is, the
longer the ice making will take;
✔
Ice cube can be properly defrosted from
the machine.
Operation Instruction
•
Startup:
after proper installation, connect
the water source and turn on the power
supply, the machine will start working.
Please confirm that the machine is
operating normally when you turn it on for
the first time.
Note: In case of thunderstorm or if not
in use for a long time, please disconnect
the power and water source!
•
Self-check:
with power on for the first
time, the ice maker will do self-check and
pump out remaining water.
•
Preparing:
after the ice machine is
energized, the inlet valve opens and water
will come inside the machine until it
reaches high level;
•
Ice making:
after pre-cooling for 30
seconds, the water pump starts, the water
flows through the evaporator smoothly and
evenly, the ice cubes are gradually formed
in the ice cube tray.
•
Ice Harvest (Drop)
: after the ice making
process, the water pump is turned off, the
defrost valve is turned on, allowing the hot
gas to enter the evaporator for about 1-2
minutes, the ice cubes slides from the
evaporator into the ice bin.
Warning: Do not put your hand into the
ice ice bin during the harvest process, to
prevent the ice to hit your hand!
•
Shutdown:
The ice maker will stop
working when you click the “on/off” button
on the panel during running process.
•
Bin full stop:
in the running state, with the
ice bin filled to a certain height, the ice
sliding board cannot be rebounded or
reset because of the block of the freshly
produced ice cubes, the ice maker will
stop in 40 seconds.
•
Repeat ice-making:
when the blocking
ice cubes are taken away, the ice maker
will turn back to ice making process in a
few seconds.
