5
3. Install 4 adjustable feet on the unit, and then place the bin on the cabinet. The machine
needs to be placed in an environment of good ventilation and relatively low ambient temperature.
It should be placed horizontally, and the distance between the air outlet and the barrier should be
at least 7.5 Inch, and between the two sides and the barrier should be no less than 2 In.
The new machine must be thoroughly cleaned before use
1. Open the machine and remove the ice gate.
2. Clean the unit with neutral detergent, warm water and soft cloth.
Repeatedly clean the inner tank of the cabinet until the inner tank is clean. Please discard the
first batch ice cubes.
4. Wash the machine with water or wipe with a damp cloth and dry with a dry cloth.
During the use of the machine, regularly clean and maintain the ice
machine.
1. Repeat the above steps to clean the inner tank of the cabinet.
2. Please pay attention to the cleaning of water distribution pipe in the upper part of the
evaporator.
If compressor and pump perform normally but the water flow through the water pipe (a total of 17
small holes) is too small or no water i s spraying. Please remove the water distribution pipe
and clean it. Clean each small hole in the water distribution pipe as shown in the figure, in
order to keep all the holes clear and remove blockage. After completion, restore the water
distribution pipe (Power off before cleaning, and then remove the front panel).
3. Please clean the evaporator inner wall and the water tank regularly, which will be conducive to
the normal pumping of the machine pump. The cleaning cycle is related to the water quality.
4. If there is ice on the evaporator with strong adhesion, do not forcedly pry with objects. Please
press the "on / off" button for more than 5 seconds to forced ice process during ice making. After
all the ice is over, turn off the power and clean the machine.
Remove the top 3 screws first,
then move the front panel up.
