2
4
21
2
17
1
2
19
19
8. Install the rear-view mirror and windshield
Tighten with the door screws (part 19), as shown in
the figure2.
Assemble the rear-view mirror (part 4) on the
windshield, then tighten the rear-view mirror with
the screw (part 17) and the lock nut (part 21).
9. Open the car door
Install the windshield (part 2) at the assigned
location of the car front end, find each
clip
position
before installation, and then press it
firmly
until each
clip
position is tight.
Push the switch in the car door panel forwards,
swing
the car door outwards and open the car door.
A
C
26
B
A
C
B
10. Install pull grip
Press height
setting button
Push down
the push rod
Installer should stand at the rear of the car. As shown in
the figure, align with the the small bump at the bottom of
the push rod, hold the lower end of the push rod with
your left hand and push rod head with your right hand.
Press the push rod button with the thumb; Push down
the push rod with the right hand. observe and make
sure the two small bumps at the bottom end of the push
rod are completely retracted. At the same time, insert the
push rod into the bottom of the rear mounting hole.
When your here the click, then turn the push rod to
control the front wheel steering.
1
2
Blue cable
Circuit board
placing box
Black cable Battery black-plug (-)
Battery
red-plug (+)
Red cable
Over-current
protection
2
Blue cable
Black cable
Battery
red-plug (+)
Circuit board
placing box
Battery black-plug (-)
Red cable
Over-current
protection
Operation of overcurrent protector
1)
The overcurrent protector is installed under the seat.
You can see it by
removing
the seat screw
(as
shown in the figure) and taking the seat away.
2)
When the car is overloaded, the overcurrent
protector automatically disconnects the circuit (for
protecting the circuit); when the circuit fault is
removed, the overcurrent protector automatically
connects the circuit.
3)
When the battery has power and the car can not run,
please check whether the circuit of the car has an
open circuit or short circuit.
(Option A, Option B)
(Option C, Option D)
Warning
Fire danger! The overcurrent
protection is only limited to 4A.
Warning
Fire danger! The overcurrent
protection is only limited to 4A.
VIII. WARNING
1. Battery warning:
1)
2)
If the product is not used for a long time, please fully charge the battery and then turn off
the power switch for storing the car. The battery shall be recharged once every other month,
otherwise the battery service life will be shortened or the battery cannot be charged again.
Pay attention to the positive and negative
terminals
of the battery during installation (the
reverse connection or short circuit of the positive and negative
terminals
of the battery is not
allowed to occur).
Battery warning:
1)
This product needs to be provided with two DC 1.5V AAA batteries (not included in this
product).
2)
Pay attention to the positive and negative poles of the battery during installation (the
reverse connection or short circuit of the positive and negative poles of the battery is not
allowed to occur).
3)
Rechargeable batteries charging operation can be carried out only by adults.
4)
Non-rechargeable batteries cannot be charged.
5)
The rechargeable batteries can be charged only after being taken out from the remote
control battery compartment.
6)
Please do not mix different types of batteries or used batteries and new batteries.
7)
If this product
will
not been used for a long time, the batteries shall be taken out from the
remote control battery compartment.
8) Exhausted batteries are to be removed from the toy.
