18
18
18
18
10
10
18
18
18
18
9
9
11
12
1
Black cable
A
A
Blue cable
Battery
black-plug
(-)
Battery
red-plug (+)
Red cable
Over-current
protection
Circuit board
placing box
Black cable
Battery
black-plug (-)
Battery
red-plug (+)
Red cable
Over-current
protection
Circuit board
placing box
Blue cable
4. Installation of power supply
(Optional A, Optional B)
(Optional C, Optional D)
After installing the power supply, assemble the seat (part 9) on the specified position and tighten it with the
seat screw (part 18). Then mount the seat backrest (part 10) on the specified position and tighten it with the
seat backrest screw (part 18).
Insert plug (A) into the circuit board to its bottom.
Insert plug (A) into the circuit board to its bottom.
5. Mount seat and seat backrest
6. Installation of tail wing
7. Install the window
Insert the window (part 12) into the designated position
on both sides of the car-body. Before installation,
please press each
clip
position to firmly connect.
Insert the
tail wing
(part 11) into the
corresponding hole along the arrow direction
and then tighten the screw.
Socket
Socket
Charging
plug
Charging
plug
24
VII. Simple Fault Removal Guidance
Trouble
1. The car cannot be started
2. Music sound is distorted
or silent
Key points of inspection
1) (Option A, Option B) Check if the battery is fully charged, and you can observe the
display of the central control panel to check whether the voltage is above 12V.
(Option C, Option D) Check if the battery is fully charged, and you can observe the
display panel of the central control panel to check the voltage is above 6V.
2) Check the power switch, all plugs of the dash receiver under the seat, and the battery
terminal line are properly inserted.
3) Check whether the circuit of the over-current protector is automatically disconnected
(when the motorcycle is overloaded and blocked, the circuit of the over-current
protector will be disconnected to protect the motor and dash receiver.)
4) Check whether the car has been stored for a long time and its battery is not
charged on time.
5) If the remote control cannot start the car, please check whether the remote control
pairing
function is properly operated.
6) Check whether the remote control battery power is low.
Check whether the battery power is enough, and charge or replace the battery if not.
4
2.4G remote control
First gear, second gear
and third gear lamps
Forward/backward button
Sudden brake button
Speed change button
Left/right movement button
(Optional B, Optional D)
VI.
Battery and Charger Operating Guide
Power Supply
Battery specifications
Over-current protection
Charging Source
Battery charging time for
every time
Chargeable type
(See the option parameters)
(See the option parameters)
Input AC 100V-240V
50Hz/60Hz
Charging Time: 9-10 hours
Output (see charger parameters of the
product)
Utility time: 1-2 hours
1.
The charging socket is located at the lower part of the car seat.
2. Only use battery and charger as recommended by the manufacturer.
3.
Please do not play with the charger and battery because they are not toys.
4.
5.
The battery charging operation must be completed by adults only.
The battery shall be fully charged before first use, not
exceed 15 hours.
6. C
harge immediately if the displayed voltage goes as low as
9.6V
(Option A&B) or 4.8V (Option C&D).
7.
The charger or battery may become warm during
operation, this is normal.
