11
KON SOBEK Drives GmbH · Etzwiesenstraße 35/1 · D- 72108 Rottenburg am Neckar
Tel: +49 (0) 7457/9435-0 · Hotline: 0800-Brushless · Fax: +49 (0) 7457/9435-90 ·
E-Mail: [email protected]
5. Now connect the ProgUNIT with the supplied
USB cable to your PC.
6. When connecting the ProgUNIT to the PC, the
currently installed software version is shown in
the window (see below). The
Update
button is
now selectable. Run the update from your PC by
clicking the update button.
7. The update will be executed automatically.
8. During the update it is recommended not to
disconnect anything of the items: PC / ProgUNIT,
ProgUNIT / KONTRONIK ESC, KONTRONIK
ESC / battery.
9. During the update no additional work should be
done on the PC, otherwise the progress bar may
appear to be frozen. Nevertheless the update is
still running!
10. When the update has been completed
successfully a confirmation of the new software
version appears in the software update screen.
11. After a successfully completed update all con-
nections can be disconnected. The KONTRONIK
ESC should be reset to Mode 1. After this the
KONTRONIK ESC is ready for standard mode
programming.
WARNING: all previously made preferences
will be reset; the mode programming must be
redone.
4.2 Updating the ProgUNIT
Before updating the software of your ProgUNIT please
read the currently installed software version via the
PC programm.
Please visit KONTRONIK homepage for the most
current version of firmware (www.kontronik.com):
DOWNLOADS - ProgUNIT. If a later software version
is available, please download and save the file on
your local Windows™ PC and execute the file
afterwards. The screen below will be displayed.
Press the button on the backside of the ProgUNIT and
hold it. Connect the USB port of the ProgUNIT via the
included USB cable to your PC,
still keep the button
pressed!
The green LED is on. Wait until the red LED
beginns blinking. This procedure may take five to six
seconds. After the red LED beginns blinking, please
release the button.
Cllick on the button
Update
on your PC to install the
new software version.
After finalizing the update, the ProgUNIT can be
disconnected from the PC.
This procedure can be repeated if desired.
!
!
