Kontron MOPSlcd6, Technical Manual

Page: 34 / 42

MOPSlcd6 Specifications
p588m115.doc
JUMP tec

Industrielle Computertechnik AG
Page: 34 of 42
12. SPECIFICATIONS
12.1 Mechanical Specifications
PC/104 Bus connector: 2 pieces of 2*32 pin male and 2*20 pin male connector
PC/104plus connector 4*30 pin 2mm connector
REMEMBER: The PC/104plus connector is without connector shroud. It’s not possible to use
a PC/104plus board with connector shroud at top at MOPSlcd6 and MOPS/686+. This is only a
mechanical limitation and does not reduce the functionality of MOPSlcd6 and MOPS/686+.
Please order a module without connector shroud or place MOPSlcd6/ MOPS/686+ at top at the
stack.
Module-dimensions: length * width 95 mm * 90 mm (3,7" * 3,5 ")
12.2 Electrical Specifications
Supply voltage: 5V DC +/- 5%
Supply voltage ripple: 100 mV peak to peak 0 - 20 MHz
Supply current (maximal): 1,8 A + current DRAM + current Prozessor
(
Σ
max. current all Parts)
Supply current (typical, DOS-Prompt):
with 166 MHz CPU and 64 MB SDRAM 1,60 A
with 266 MHz CPU, Fan and 64 MB SDRAM 1,85 A
external RTC battery voltage 2,4 – 4,0 V
external RTC battery quiescent current max. 2 uA
The MOPSlcd6 is not a replacement for a backplane! It’s strictly recommended to use
all Power Pins on the PC/104 connector for power supply of the MOPSlcd6 and
additional I/O cards.
The MOPSlcd6 is not a replacement for a backplane! It’s not acceptabel to use only the
power pins of the PC/104plus PCI connector for power supply of the full PC/104 stack.
The MOPSlcd6 is not a replacement for a backplane! Please refer the PC/104plus
specification for the power supply of the MOPSlcd6 and all additional PC/104 I/O-cards.
12.3 Environmental Specifications
Temperature: operating 0 to +60
°
C ((*)with appropriate airflow)) except CPU and chipset (see
below)
non operating: -10 to +85
°
C
The Intel Pentium

Processor with MMX

Technology on 0.25 Micron is specified for proper
operation when case temperature is within the specified range of 0
°
C to 95
°
C.
The chipset M1531 and M1543C on the back side are specified for extended temperature
range of 0
°
C to 85
°
C.
Humidity: operating: 10% to 90% (non-condensing)
non operating: 5% to 95% (non-condensing)
(*) The maximum operating temperature is the maximum measurable
temperature on any spot on the modules´s surface. It is the user´s
responsibility to maintain this temperature within the specification, which is set
by the IC manufacturer.