MOPSlcd6
Hardware Description
p588m115.doc
JUMP
tec
Industrielle Computertechnik AG
Page: 26 of 42
9.5 Onboard C&T VGA
Block Diagram
Intern
PCI-
BUS
HiQV64
with 2 MB RAM
CRT
internal
panel connector
plug-and-play
Supported Display Types
The
MOPSlcd6
supports a vast variety of panels all configured by a dedicated cable for each panel.
There is no jumper setting or software setup required. Since practically all LCD’s have different
connectors, pinout or LCD voltages, this is the easiest and safest way to configure different panels.
The
MOPSlcd6
BIOS supports different panel types, which are identified via the video BIOS by
reading the configuration on internal panel connector.
Power Supply
The on board 3.3V-circuitry and low-voltage panels are powered by their own separated voltage
regulators, the one for the LCD is mounted on the adapter cable. If the used backlight converter needs
+12V, supply system also with +12V.
The LC-Display Interface
Connecting a Display
Many different panel adapters for a wide spread variety of displays are available through
JUMP
tec
®
. If
you use one of those adapters supplied by
JUMP
tec
®
, configuration is very easy:
1. Check, whether you have the correct adapter and cable for the panel you plan to use. Inspect the
cable for damages.
2. Disconnect power from your System.
3. Connect the panel adapter to the internal LCD connector on
MOPSlcd6
.
4. Connect the other end of the cable to your display.
5. Connect the backlight converter.
6. Supply power to your system
7. If no picture appears on your display, you should connect a CRT monitor to the CRT-connector.
If you still don’t see any improvement, you may consider contacting the dealer for technical
support.
