KISS
Oil & Gas
2U User’s Manual
Fig. 30: Chassis Filter
Fig. 31: Back side of ventallation cover where chassis filter fits.
To clean or replace the chassis filter, proceed as follows:
1.
Remove the filter cover by unscrewing the two knurled screws on the front.
2.
Remove the dirty chassis filter by lifting it off the front ventalation cover. It fits securely. There are no
screws to hold the filter in place.
3.
Replace the dirty filter with a new filter (Kontron part 409-0174-00) or clean the existing filter.
4.
Clean the chassis filter as follows:
»
Rinse in water (up to approx. 40°C/104°F; you may add a mild commercial detergent).
»
It is also possible to beat it, suction clean it or blast it with warm compressed air.
»
If the filter is soiled with greasy dust, you should rinse it with warm water with degreaser added. Do
not clean the air filter mat with a piercing jet of water or wring it out.
5.
After cleaning and drying the chassis filter, place it in the filter cover holder with ventilations. Re-
attach the chassis cover to the front of the chassis.
6.
Screw the chassis filter cover to the chassis front.
A defective chassis filter may be replaced only by a Kontron original spare part.
»
Chassis filter: Part number: 409-0174-00
42
www.kontron.com