10. Maintenance and Prevention
KISS 4U V2 – User's Guide (Version 1.01)
10.2.
Replacing the System Fans
The operation of the KISS 4U V2 system is permitted only with a functional fan slide-in module!
Defective components may only be replaced by Kontron original spare parts.
part number of the fan slide-in module: 1035-6968
The fan slide-in module can be replaced during operation. This should only be carried out by a qualified
specialist or a suitably instructed user, who is aware of the associated dangers.
Keep your hands and fingers away from rotating parts of the fans. Before taking out the fan slide-in
module, wait until the fans have totally stopped.
To replace fan slide-in module, proceed as follows:
1.
Remove the filter mat holder as described in chapter 10.1 “Cleaning the Filter Mat” (step 1 to 3) and put it aside for
later reassembly.
2.
Loosen the two knurled screws of the fan slide-in module (Fig. 45, pos 1)
3.
Pull the fan slide-in module out of the cabinet using the knurled screws to disconnect it from the internal fan control
socket (Fig. 46, pos. 4).
4.
Lift the fan slide-in module as shown (Fig. 45, pos. 2) out of the fan compartment (see Fig. 46).
4
1
Fig. 45: Detail: Fan slide-in module without filter mat holder
Fig. 46: Detail: Fan compartment (without fan slide-in module)
Legend for
and
1
Fan slide-in module with two knurled screws
2
Fixing plate for the fan slide-in module (chassis)
3
Front access panel
4
Socket for fan power supply and control
5
Fan compartment
2
2
1
1
2
3
5
2
40
www.kontron.com
