KBox A-150-HSW - Rev. 1.0
// 27
After changing the mSATA SSD the partitioning of the memory maybe different and require
the system to be repartitioned.
7.2.
Accessing Internal Components
7.2.1.
Opening the Chassis
To access the internal components open the KBox A-150-BT chassis by following the step below:
The KBox A-150-HSW is factory configured to meet customer requirements. Kontron does
not recommend opening the system as this may cause damage to internal components.
1.
Close all applications. Shut down the system properly and disconnect the power cord from the power source.
Disconnect all peripherals.
2.
Place the KBox A-150 BT on a flat, clean and ESD-safe surface.
3.
Remove the three screws at the top, right and left sides of the front panel, see Figure 11: Front Panel Fastening
Screws
Figure 11: Front Panel Fastening Screws
4.
Remove the two screws from the bottom side of the chassis.
Figure 12: Bottom Side fastening screws
5.
Carefully side the cover of the chassis
Remove the three screws indicated.
Remove the two screws indicated.
