FlexATX-KBL-S-C236 – Rev. 1.1
www.kontron.com
// 57
Sub-Screen
Function
Description
command time-out
Device power-up delay
Maximum time for the device will take
before it properly report itself to the
Host Controller
LVDS
Configuration
LVDS Flat Panel Display Support
Enable/Disable LVDS Flat Panel Display
Support
Panel Type
Select the type or Manufacturer’s name
of the display panel
Resolution
Select the screen resolution of the
display panel
Panel Color Depth
Select the display panel color depth
Panel Voltage
Select the voltage level for powering the
LVDS Display Panel
Channel
Select LVDS Interface Signals mode
Single-Channel or Dual-Channel
(Sometimes called “Single-Pixel” or
“Dual-Pixel”)
Bus Swapping
Swap LVDS interface signals: Normal –
use bus as indicated by pin name,
Swapped – swap odd bus signals with
even bus signals
Clock Frequency Center Spread
Programmable center spreading of pixel
clock frequency to minimize EMI
Differential Output Swing Level
Programmable LVDS signal swing to
pre-compensate for channel
attenuation or allow for power saving
Backlight
Enable/Disable Backlight
Backlight Signal Inversion
Enable – Active High
Disable – Active Low for display panel
Backlight signal
Backlight PWM Frequency
Set the PWM frequency the backlight
Brightness Level
Select the Brightness Level for the
backlight of the display panel
Hardware
Health
Configuration
System Temperature
Display the System Temperature
System Temperature Offset
Adjust the offset value in C (Two’s
Complement)
CPU Temperature
Display CPU Temperature
System Fan Speed
Display System Fan Speed
System Fan Cruise Control
Disable = Full speed
Thermal = does regulate fan speed
according to specified temperature
Speed = does regulate according to
specified speed
