www.kontron.com
CP6924-1-RA-A User Guide
19
2.2
CP6924 Initial Installation Procedures
The following procedures are applicable only for the initial installation of the CP6924 in a system. Procedures for standard
removal and hot swap operations are found in their respective chapters.
To perform an initial installation of the CP6924 in a system proceed as follows:
1. Ensure that the safety requirements indicated in chapter Safety Requirements are observed.
2. Ensure that the board is properly configured for operation in accordance with application requirements before in-
stalling. For information regarding the configuration of the CP6924 refer to the CLI Reference Manual.
3. To install the CP6924-1-RA-A refer to the system manual.
4. The CP6924 is now ready for operation.
WARNING
Failure to comply with the instruction below may cause damage to the board
or result in improper system operation.
WARNING
Care must be taken when applying the procedures below to ensure that nei-
ther the CP6924 nor other system boards are physically damaged by the
application of these procedures.
