Kontron CP3005-SA, User Manual

Page: 43 / 102

CP3005-SA – Rev. 0.6 Preliminary
www.kontron.com // 43
4.3.15. LED Control Register (LCTRL)
The LED Control Register enables the user to switch on and off the front panel General Purpose LEDs.
Table 27: LED Control Register (LCTRL)
Address 0x291
Bit 7 6 5 4 3 2 1 0
Name LCMD LCOL
Access R/W R/W
Reset 0000 0000
Bitfield Description
7 - 4 LCMD LED command:
0000 = Get LED0
1000 = Set LED0
0001 = Get LED1 1001 = Set LED1
0010 = Get LED2 1010 = Set LED2
0011 = Get LED3 1011 = Set LED3
0100 - 0111 = Reserved 1100 - 1111 = Reserved
3 - 0 LCOL LED color:
0000 = Off
0001 = Green
0010 = Red
0011 = Red+Green
0100 - 1111 = Reserved
The LED Control Register can only be used if the General Purpose LEDs indicated in the “LED
Configuration Register” are configured in General Purpose Mode. The status of certain LEDs
can be obtained by writing a “Get LEDX” command where “x” is the LED number (color bits
are ignored) followed by a simple read.
4.3.16. General Purpose Output Register (GPOUT)
The General Purpose Output Register holds the general purpose output signals of the rear I/O CompactPCI connector
J2. This register can only be used if the CP3005-SA is ordered as a rear I/O version and the rear I/O GPIO operation is
configured through the dedicated rear transition module configuration signal on the CompactPCI connector J2.
Table 28: General Purpose Output Register (GPOUT)
Address 0x292
Bit 7 6 5 4 3 2 1 0
Name Reserved
R
00000
GPO2 GPO1 GPO0
Access R/W R/W R/W
Reset 0 0 00
Bitfield Description
2 - 0 GPO2..0 GPO2..0 General purpose output signals (3.3V LVTTL):
0 = Output low
1 = Output high