KONTRON
coolMONSTER/S User’s Guide
43
Power Interface
22.
POWER INTERFACE
The
cool
MONSTER/S
is not a replacement for a power supply. It is a +5V only board. Additional
voltages (+12V, -12V, and -5V as well as +3.3V for external PCI-devices) are not generated onboard.
If peripheral devices require these voltages, they have to be supplied through the backplane and
the PISA bus.
In some applications, the
cool
MONSTER/S
is intended for use as stand-alone module without a
backplane. You need to have a power connector available on the board for direct power supply.
Power signals from Connector X6 are not meant to supply power.
22.1
Connector
The power connector is available through the Connector X4 (5 pins) and e5V and +12V
power supplies to the system. For ATX power supply signals, refer to additional information in the
Feature Connector section.
Header
Pin
Signal Name
Function
1
+12V
+12V
2
VCC (*)
+5V
3
VCC (*)
+5V
4
GND
Ground
5
GND
Ground
The connector is from manufacturer MOLEX. To find the location of the connector and obtain
information about mating connector, see Appendix E: Connector Layout.
Notes
:
(*)
To protect external power lines of peripheral devices, make sure that
-- the wires have the right diameter to withstand maximum available current
-- the enclosure of the peripheral device fulfils fire-protection requirements
-- of IEC/EN 60950.
The current of the pins on this connector is limited to 7A/pin.
StockCheck.com
