1. Fit one magnet into one of the pockets in the
assembly plate.
2. Swing the wire Loop into the slot in the arm.
3. Screw one grub screw into the arm until it is
flush with the top face.
The screw should pass cleanly through the hook
on the end of the wire loop and screw down
flush with the arm. If it feels tight as you screw it in
do not force it. Back the screw off, reposition the
hook and try again.
Repeat for the second arm.
1. Fit magnet
2. Fit wire loop
3. Fit screw
cutaway detail view
A
Flush
Tensegrity Table assembly instructions page 17 of 46
Copyright Kontax Engineering Ltd 02/11/21
