6
Note: Any other form of cleaning or cleaning agents may damage the finish on
the unit.
Changing the Air Filter
It is important to change the air filter approximately every 30 days or when the
air filter turns gray.
1) Remove the air filter cover by gently pulling fowward
2) Discard the gray air filter.
3) Replace with a new, clean air filter
4) Securely reattach the air filter cover to the unit.
Note: Air filters cannot be cleaned or washed. Only Our air filters can be used.
Do not substitute alternate material such as cotton. Do not operate without an air
filter.
Assembling Your Nebulizer
Follow the cleaning instructions in this manual under “Cleaning Technique”
prior to using your nebulizer for the first time or after it has been stored for an
extended period of time.
Remember: Always unplug the Compressor and make sure the POWER switch
is turned to the “ off” position before cleaning, assembling and before and after
each use.
1) Place the Compressor on a flat, stable surface within reach, with the handle
facing toward you.
2) Open the storage compartment by lifting the lid. Remove the
contents( Nebulizer, mouthpiece and air tube).
3) Gently twist and pull straight up on the lid of the Nebulizer to separate into
two parts( medicine cup and cover)
4) Make sure that the orange jet is properly installed inside the medicine
cup( The stem inside the medicine cup inserts into the tube of the orange jet).
5) Add the prescribed amount of medication to the medication cup.
6) Reassemble the Nebulizer by carefully twisting the medicine cup and cover
together. Make sure that the two parts fit securely.
Operating Your Nebulizer
Note: The Nebulizer is operable at up to a 45 degree angle.
1) Attach one end of the air tube connector to the air stem.
2) Carefully attach the opposite end of the air tubing connector to the stem at
the base of the Nebulizer.
3) Attach the angled mouthpiece or optional mask to the top of the Nebulizer.
If using the optional tee adapter set,
a) Attach the tee adapter to the top of the Nebulizer
b) Connect one end of the tee adapter to the straight mouthpiece and the other
to the extension tube.
