str. 10
Koliber Safes
d.
Check correct operation of the lock while the safe door is open
(open and extend bolts
several times).
e.
If the lock operates correctly, replace the battery compartment cover and close the safe.
3.
If the battery is inside the safe (most often on internal side of the safe door):
a.
Open the safe.
b.
Remove the black cover of the battery compartment located on the inside of the safe door.
c.
Replace the battery noting the polarity - the markings "+" and "-".
d.
Check correct operation of the lock while the safe door is open
(open and extend bolts
several times).
e.
If the lock operates correctly, replace the battery compartment cover and close the safe.
4.
If the battery is located on the internal side of the safe door and the lock cannot be opened, as well
as the safe door are closed:
a.
Check whether the lock keypad has special contact pins to applicate additional battery and
emergency lock opening.
b.
Replace the battery noting the polarity - the markings "+" and "-".
c.
Hold the whole time additional battery with the contact pins, open the lock with normal code
and then unlock the safe door.
d.
After unlocking the safe door additional battery can be detached and the old battery can be
replaced as described above.
Warning:
Make sure that the ends of the battery with positive and negative polarity are matched correctly,
as marked in the battery compartment. If the battery is installed incorrectly, running the lock will not be
possible.
There are locks supplied more than one battery, in such cases, replace all the batteries at the same time. Do
not mix old and new batteries or mix batteries of different types (for example, alkaline and lithium batteries).
Batteries should not be opened, punctured, loaded, installed, or exposed to fire, heat or water. It is
recommended to only use alkaline or lithium batteries of known brands.
Installation of shelves
Safes are delivered with shelves packed separately and placed on the safe’s bottom. After unwrapping the
shelves, the shelf clips (in a bag) are located in the corresponding perforations in the battens (fig.2). Place the
shelves on the clips. The location of the shelves depends on the needs of the user and can be adjusted.
Rys. 2. Installation of shelf clips
* Concerns safes bought with shelves.
Use
The product should be used in rooms protected against weather elements and away from substances
corrosive to metals. Relative humidity in the room up to 75%. The device can be operated in rooms with
temperature within the range of +5°C – +40°C.
