Konsberg AIS 200, Installation Manual

Page: 32 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Installation
3.6.1.2 Bracket mounting (option)
When the MKD is bracket mounted (item A101-14), it is not weatherproof from the back.
When bracket-mounted, the exposed parts of the plugs should be protected against salt
corrosion.
1. Locate the cradle on the mounting site and mark the 4 holes for the screws on the mounting
surface.
2. Drill the 4 holes and screw the cradle to the mounting surface.
3. Use the supplied screws to fasten the MKD to the left and right brackets.
4. Apply the front panel corners.
5. Use the two locking knobs to assemble the cradle with the left and right brackets and
adjust the MKD for the best viewing angle.
3.7 Optional MKD unit
3.7.1 Mechanical installation
Note!
Please be aware that the optional MKD does not support the following
functionality:
1)
LAN diagnostics/activity check
2) Gyro calibration
3) Reset GPS
4) Reading of setup file
The optional MKD may be panel or bracket (option) mounted. The optional mounting bracket
may be ordered separately.
The unit should be mounted with special regard to the operator’s need for easy operation.
Avoid mounting the MKD where it is easily exposed to sunlight, as this will shorten the
lifetime of the display. If this is not possible, make sure the units are always covered with the
protective cover when not in use.
3.7.1.1 Panel mounting
Make sure that the mounting location includes space for plug and cable bend.
The mounting surface must be flat and even to within 0.5 mm.
22