USAGE NOTES / FUNCTION
5. DIMENSIONS
6. CASTERS
6.1
Swivel casters with brakes (2x)
6.1
- are located below the handle tube
6.2
Fixed castors, stationary (2x)
7. CAPACITY
7.1
Up to 12 orchestra music stands of the
7.1
K&M series 11930, 11924 and 11925
8. OPERATION MODES
8.
- see also chapter SAFETY INSTRUCTIONS
8.1 TRANSPORT MODE
8.1
- Hold the handle tube
b
with your hand.
8.1
- Release the brakes of both swivel castors
6.1
with
your foot.
8.1
- Guide the trolley in the desired direction with
8.1
-
the hand on the handle tube.
8.1
NOTE: Do not release the handle tube of the trolley
8.1
NOTE:
during transport mode.
8.2 PARKING MODE
8.2
- Brakes on both swivel casters must be engaged, i.e.
8.2
-
pressed down. Apply brakes by foot.
8.2
NOTE: Never park the trolley on an inclined plane.
CHECK, MAINTENANCE, CLEANING
- In the event of workstation maintenance pay attention
-
to possible risks (wedging…)
- To care for the product use a damp cloth and a non-
-
abrasive cleaning agent
FAULT-FINDING (F) and REPAIR (R)
F: Handle tube
b
is not stable
F:
R: Check screw connections
2.2
and
F:
R:
tighten or replace as needed
F: The trolley tips or does not roll properly
F:
R: Check the casters, replace if needed
6
F:
R: Check if the surface is suitable
F: Orchestra Music Stands moves back and forth
F:
R: Place orchestra music stands (see
3.2
-
3.8
) as
F:
R:
described above
F:
R: Place rubber cord
4.1
,
4.2
F:
R: Place the orchestra music stand as far as they
F:
R:
will go towards the handle tube
3.1
5. DIMENSIONS
6. CASTERS
7. CAPACITY
8. OPERATION MODES
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
11934-000-55 Rev.02 03-79-942-00 1/22
TECHNICAL DATA
Material
Tubes, guide rails: Steel, powder coating
Connection elements: Steel, galvanized
Edge protection profile: Steel, PVC
Casters: TPE
Load capacity up to 12 Orchestra music stands
Dimensions
W x D x H: 510 x 1180 x 165 (925) mm
Casters: ø100 mm, Ground clearance: 112 mm
Weight
13.4 kg
Packaging
1230 x 570 x 210 mm
4. SECURING the LOAD
To avoid unintentional movement of the
load a rubber cord
c
is used to secure the
load.
4.1
Guide the rubber cord hook
4.1
into the drill holes on both
4.1
sides of the side guide rails
4.2
Secure the cord over both legs and hook it
4.2
into the hole located on the other guide rail
4. SECURING the LOAD
