USER TIPS / FUNCTIONS
AFTER USE
- Dismantling is done in reverse sequence to setting up.
- Tip: First open gray clamping lever (12) then raise the upholstered seat by means of a rotary motion.
- It is recommended for transport and long-term storage to separate leg construction and upholstered seat and store them in their
-
original boxes.
MAINTENANCE AND CLEANING
- During maintenance work, be aware of potential hazards (pinching, pain).
- It is recommended to use a slightly damp cloth and non-abrasive cleaner for cleaning.
FAULT-FINDING (F) and REPAIR (R)
F: Upholstered seat turns too easily or too heavily out of the extension rod: Pre-setting of the grey clamping lever is wrong:
R: By turning the screw attached, the clamping (13-14) effect may be corrected.
F: Height adjustment of the extension rod is heavy-going:
R: Possibly some debris or dirt is stuck between the tubes: clean carefully.
R: Pre-setting of the grey clamping lever is possibly too tight: correct by turning the screw (12) attached.
F: Tight leg construction:
R: Apply some silicon spray.
ACCESSORIES / EXTRAS
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
14000-000-02 Rev.27 03-80-140-00 1/18
®
"Buttkicker" is a registered Trademark of the
Guitammer Company Inc. / Sale: Fischer Amps
1. HEIGHT ADJUSTMENT
- Open grey clamping lever (7).
- Pull the pull-button (8) and
-
adjust extension rod (9) to the desired height.
- Let pull-button (10) snap in the appropriate slot.
- Close grey clamping lever (7) again.
A. Spikes (Art.-no.14002):
Replace the pre-mounted Allen screws (15) with the spikes.
WARNING: Negligent handling of the spikes might lead to major injuries;
in addition, the spikes (16) will cause imprints in the floor.
B. Tuning key holder (Art.-no.14001):
Consists of plastic holder with snap catches, tuning key,
and Spax screws. To be attached to the bottom side of the seat (17).
Sufficient space also for a Sonor MK multi key.
C. 4 threaded screw sockets:
You will find them at the back of the bottom side of the seat.
Provided for a possible attachment of a "Buttkicker"
®
.
The screw sockets are underneath the leather cover which, if needed,
must be cut open at the respective spots (18).
Attachment by use of 4 screws (M6 x 25 mm, i.e. M6 x 30 mm)
and matching U-discs.
3. SET ROTATION OF SEAT
Options: Rotation can be set from easy to stiff
- Open grey clamping lever (13).
- Loosen or tighten the screw attached (14)
-
(within one full turn)
- Close grey clamping lever (13) again.
2. PRE-TIGHTEN GRIPPER CLAMP (11)
For the clamp to function efficiently, a certain amount of strength needs to be
applied when closing the clamping lever (7). If the clamping lever closes too
easily it should be re-adjusted:
METHOD:
- Open the clamping lever (7) and turn the Allen key (12) to tighten.
- Re-close the clamping lever and if still not tight, repeat the
-
readjustment process.
AIM:
a. When the clamping lever is closed (11) the extension rod (9)
a.
must be fixed and held in place by the gripper clamp.
b. When the clamping lever is open, the extension rod can be adjusted to the desired height.
