24613 Rigging
- Component of the Speaker/Lighting Stand K&M 24610
- also available for other K&M stands with extension tube diameters from 30-35 mm:
- with 3 fastening points for the rigging lines
SAFETY NOTES
- The stand must be set up properly (load bearing weight, surface etc.)
- Should horizontal forces (e.g. wind) affect the stand; this can negatively affect stand stability.
-
Counter measures should be taken e.g. rigging or placing weight on the base.
- The clamping ring must be firmly affixed to the stand:
-
The threaded pin is to be screwed in until it can no longer be moved manually.
- Proper rigging of the stand:
-
- rig 3 lines at an angle of 120° respectively (2 lines or even 1 line provide less stability).
-
- Check line, anchor and connection elements (quality and dimensions); The three drill holes for the rigging lines are 10 mm.
-
- Expert setup of the rigging is required.
-
- Check the functionality and safety/stability of the rigged stand prior and, if needed, during use:
- -
Is the stand plumb/vertical? Is the clamping ring set such that it cannot move/slip? Are the lines taught?
- -
Are the connections and anchors fixed?
- Please mark or block off danger zones accordingly.
-
The lines themselves can also represent a risk/danger. We recommend K&M warning strips 21402 to mark the danger zone.
USAGE INSTRUCTIONS
Thank you for choosing this product. The instructions provide directions to all of the important set up and handling steps
We recommend you keep these instructions for future reference.
A.
COMPONENTS
1
Clamping ring aluminum
2
Threaded pin with a tip
2
and hexagon socket M6 x 15 mm
3
Hexagon key SW 3
4
Instructions
B.
ASSEMBLY of the clamping ring
a.
PREPARATION of the clamping ring:
a.
the tip of the threaded pin
2
may not
a.
peak through the drill hole of the ring
a.
- if needed pull back the threaded pin
a.
using the key
3
.
b.
PLACEMENT of the clamping ring:
1. Regarding: Stands 246/1, 21300, 21302:
1.
Place the clamping ring
1
on
1.
the extension tube up to where the tube
1.
expands a bit.
2. Regarding: All other K&M stands (refer to
2.
Tech. Data). If the tube does not expand a
2.
bit - the ring can be positioned anywhere
2.
on the expansion tube.
c.
SECURE the clamping ring
1
- first select a position (see
b.
)
1. Tighten the threaded pin somewhat.
2. As soon as the tip reaches the tube wall,
2.
a half turn of the hexagon key is usually
2.
enough
3
to secure the ring
2.
- PAY ATTENTION !
2. -
The tip of the threaded pin
2
is within the
2. -
tube. This ensures that the clamping ring
2. -
is secure and fixed. The clamping ring
2. -
can no longer be turned or removed
2. -
manually.
2.
- Check that the clamping ring is secure
2. -
prior to and after installing the rigging
2. -
lines.
➀
➁
➂
➃
a
c
b
