TECHNICAL DATA
Material
swivel joint, holder-plate: Polyamid (PA-6)
screws, nuts, washers, springs: steel
Max. load
iPad 2. Generation (630 g), iPad 3. Generation (670 g)
Size
base dimensions: 252.1 x 104.8 x 195.4 mm
card box: 300 x 102 x 230 mm
Weight
net 0.54 kg, gross 0.82 kg
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
19712-300-55 / 19712-500-55 Rev.07 03-80-127-00 7/12
USERS TIPPS / DIMENSIONS
MOUNTING INSTRUCTIONS
19712 iPad Stand Holder
- Strength and stability! A clever way to show off your iPad.
- The new mount guarantees to hold the iPad effectively and safely.
- For use on stage, in the rehearsal room or at home
- With thread for microphone stands (3/8" or 5/8").
- The iPad is clipped in and out of the holder effortlessly.
- An easy-to-use wing nut adjusts the tilt so the user can easily find a position to suit them.
- The iPad can rapidly switched between the vertical an horizontal format, whereby slip is
-
prevented.
SAFETY INSTRUCTIONS
Thank you for choosing this product. This instruction manual informs you about the important steps to set
up an handle the product. We recommend to keep the manual in a separate place for a possible later use.
(FF) FAULT FINDING & (R) REPAIR
FF: holder wobbles
FF:
R: Tighten stand-holder-screwing (see mounting
FF: R:
instructions
1-3
)
FF:
R: Tighten wing nut
4
FF: iPad wobbles
FF:
R: Lock in place iPad correctly
5
- let´s hear the "click"
FF: R:
noise
6
FF:
R: Note the correct position of the iPad
11.a
,
11.b
FF:
R: ATTENTION! Not suitable for iPad 1. Generation.
SETTINGS - Tilting & Format (vertical/horizontal)
The iPad can remain in position.
TILTING
Choose any angle between 0-90°.
7
Hold the iPad and loosen wing nut
8
Tilt iPad into desired angle and
9
Tighten wing nut again
FORMAT
The iPad can be rapidly switched between
the vertical and horizontal format.
10
turn holder-plate into desired format
10
- or into slant !
10
Invisible mechanical stops limits the adjustment
TIPP
Beware of the position of the on/off-switch
11.a
- at the bottom
11.b
- on the right side.
Effect: due to the mechanical stop inside of the holder
the cord of a head phone set couldn´t cause a rotation.
The iPad 2 stand holder is very easy to attach.
Use a suitable stand (see SAFETY INSTRUCTIONS)
1
first screw on the disc (3/8", 5/8") to the stand
1
until stop
2
then screw the iPad stand holder onto the stand
3
tighten iPad stand holder with the disc
4
tighten wing nut
5
place iPad into the holder-plate and
6
clip in the iPad at last.
For removal please notice reverse order.
- suitable for
iPad 2. or 3. Generation
, not suitable for iPad 1. Generation
- Use suitable stands w.stability, support, centric loading and connector-thread,
-
e.g. any KÖNIG & MEYER - microphone stand
- clip in the iPad carefully and check the correct positioning
- handle with care, particularly while changing the setting (tilting, vertical/horizontal format)
