E-5
18. Adjust the skew of the hole punch position.
(1) Insert a piece of paper into the finisher’s inter-
lock to turn it ON.
(2) Turn ON the Main power switch and Sub power
switch of the machine, and make sample copies
for both the single-side and double-side with
any tray in Punch mode.
(3) Using the paper sample, check the hole posi-
tion gap by folding the paper in half.
(4) If hole position gap is found, loosen the Punch
kit fix screws (TP screw M4x6: 4 pcs.) and move
the punch kit to the left or right to the amount of
the skew.
Note:
When doing so, adjust the gap in the depth direc-
tion according to “Adjusting the vertical punch posi-
tion” on pages 8.
19. Adjust the skew of the hole punch position.
(When PI-502 is installed to the finisher)
(1) Make sample copies from the PI-502 in Punch
mode.
(2) Using the paper sample, check the hole posi-
tion gap by folding the paper in half.
(3) If hole position gap is found, loosen the finisher
guide plate fixing screw and move it to the left
or right to the amount of the skew.
20. Centering adjustment.
Execute for each paper size and tray.
(1) Make sample copies in Punch mode to check
that the punching hole is within the sensor area
when the hole is punched. (For all trays)
(2) If punching position gap is found, adjust the cen-
tering of the tray. (Refer to the Service manual)
15KJIXE019SA
P
aper
15KJIXE020SB
Output sa
m
ples
T
P
scre
w
s
M
4
x6
T
P
scre
w
M
4
x6
When
w
ide in back
When
w
ide in front
15KJIXE021SB
Guide plate
fi
x
ing scre
w
Finisher/front
Output sa
m
ples
When
w
ide in back
When
w
ide in front
15KJIXE022SA
P
unching position
should be in this range
Sensor
