E-3
10. Remove the Punch kit cover. (TP screw M3x6: 2
pcs.)
11. Remove the locking screw of the punch kit
attached to the end of the red tag.
12. Install the Punch kit.
(1) Make sure the guide pin on the inner side of
the Punch kit go into the guide hole in the Fin-
isher.
Note:
Put the Punch kit wire bundle in the finisher before
inserting the Punch Kit.
(2) Align the markings of the punch kit to the cen-
ter and secure. (TP screw M4x6: 4 pcs.)
Make sure to open and close the conveyance
guide plate/1 once so that the PET at the entrance
of the punch kit return to normal position.
(3) Connect the two Punch kit connectors to the
Punch kit, and attach the wire bundle to the
two mini wire saddles.
Note:
Arrange the wire bundle at a proper distance from
the gear.
(4) Connect the Punch kit wire bundle to three connec-
tors on the control board as shown in the figure.
15KJIXE007SA
T
P
scre
w
s
M
3
x6
15KJIXE008SA
Red tag
Locking scre
w
A04EIXE008SA
P
K-511
For
P
K-511
T
P
scre
w
s
M
4
x6
15KJIXE011SB
M
arkings
T
P
scre
w
s
M
4
x6
Conve
y
ance guide plate/1
15KJIXE012SB
P
unch kit connectors
M
ini
w
ire saddles
A04EIXE004SA
Connectors
