E-2
2. Reinstall the screws removed in step 1-(1).
3. Install the 2 positioning screws at the rear side of
the Finisher.
4. Install the PI-506.
(1) Install the PI-506 on top of the Finisher.
Note:
• To lock the PI-506 in place, first align its key-
hole slots so that the positioning screws you
installed on the Finisher feed through the wide
parts of the slots.
• Then slide the PI-506 so that the heads of the
positioning screws are locked over the narrow
parts of the keyhole slots.
Check that there is no gap between the PI-506
and the Finisher in the rear side exterior panel.
If there is the gap, install the PI-506 again.
(2) Remove the packing tape and protective mate-
rials.
(3) Connect the PI-506 connector to the connector
at the top front of the Finisher.
15JFIXC008SA
15JFIXE009SA
Positioning screws
15JFIXE010SA
Positioning screw
A10YIXC001CA
PI-506 connector
Finisher connector
