E-9
(11) Conduct the following procedure to connect the
sensor unit's connector to the main unit.
a) If present, disconnect the relay connector from
the sensor unit connector.
b) Connect the sensor unit connector to the con-
nector as shown in the illustration.
c) Route the sensor unit harness through the two
wire saddles.
(12) Install the supplied upper tray into the main unit
by fitting the tab into the hole.
Note:
Fit the two protrusions on the upper tray into the
portion where the cover has been removed in step
(7) and into the depression on the main unit’s sur-
face as shown in the illustration.
(13) Secure the upper tray with three supplied
screws B.
Protrusion
Tab
Notch
Protrusion
